Stock: 9992
- Stops water intrusion — seals the exposed factory cowl openings that let rain and wash water track down toward the cabin
- Fixes a known Grenadier problem — the OE wiper cowl plugs are notorious for working loose and falling out on the trail
- Flexible for a perfect fit — pliable material conforms to the opening for a snug, secure seal that won't pop out
- Clean, factory look — a finished, low-profile plug that looks like it belongs, not a temporary patch
- Sold as a pair — replace both sides at once so you're covered left and right
- No tools, no drilling — press-in install takes seconds
- Built for the 2024+ INEOS Grenadier
StickerFab Perfect Plugs
Seal the factory cowl openings, keep the water out, and lose the rattling OE plugs for good.
Also known as B.U.T.T. Plugs™ — Barrier Utility Trim Toppers.
Yes, really. “Barrier” for the water-sealing job they do, “Trim Toppers” for the exterior trim opening they cap off clean. And honestly? B.U.T.T. Plugs — because the factory ones keep falling out. 😄
A Small Plug, A Big ProblemThe INEOS Grenadier's factory wiper cowl plugs are known to work loose and fall out — a widely reported issue among Grenadier owners. Once one goes missing, the opening it leaves behind is a direct path for rain, spray, and wash water to collect in the cowl and track down toward the cabin. What starts as a lost 20-cent cap can end as damp carpet, musty smells, or worse near the wiring below. StickerFab Perfect Plugs put that opening back under control. Each plug is made from a flexible material that conforms to the cowl hole for a tight, secure seal — so it stays put over washboard, water crossings, and years of vibration, and it keeps water where it belongs: outside. |
💧 Why It Matters
Water intrusion is one of the most talked-about pain points in the Grenadier community. A missing or ill-fitting cowl plug is one of the easiest entry points to fix. Perfect Plugs are a cheap, five-second insurance policy against an expensive, aggravating problem.
See the Fix in ActionWatch the whole thing come together — the exposed factory openings, the drop-in fit, and the clean, sealed result. It's exactly as easy as it looks: line the plug up with the opening and press it home. Install — takes seconds. Clean the opening, line up the plug, and press it in until it seats flush. No tools, no drilling, no adhesive. Do both sides in under a minute. Sold as a pair so you can replace left and right at the same time. |
Flexible for a Perfect FitRigid plugs pop out. Ours don't. The pliable construction lets each plug compress slightly on the way in and spring back to grip the walls of the opening — a real seal, not a loose press-fit. The result is a finished, factory-clean look up top and a watertight barrier underneath. |
⚡ Clean, Factory-Correct Look
A low-profile, finished plug that looks like it belongs — not a temporary patch. Restore the factory appearance up top while sealing the opening underneath.
FAQ
|
What do these fix? |
Will they fall out like the factory ones? |
|
How many come in a set? |
Do I need any tools? |
|
What does it fit? |
Do they change the look? |